For a pool, reset the pump or filter pump breaker. Then, set the proper time in the Intermatic timer. Finally, turn on the orange or red switch below the timer. This can get your pump working again.

If you have a pool and spa, you should only reset the pool pump or filter pump breaker. No additional steps are needed.

If these steps don’t work, get in touch with Coast to Coast Pools to get troubleshooting and repairs.

There are different possibilities to consider. First, your pool could not have enough water. The water level must be halfway into the skimmer opening at the waterline tile. If it’s too low, you could have water issues. To address the issue, fill the pool to that level.

Your Weir door could be stuck. The lap inside the skimmer could be preventing water from entering. Just wiggle the flap to free it, and then it should float again and resolve your water issues.

For a weak-flowing waterfall, consider the filter. A dirty or old filter could inhibit the water flow. Have our industry experts check the filter on our next visit.

If the water level is touching the tile below the curved coping brick, then everything is okay! If you feel you need it lowered, there is a manual drain at the pump for you to lower the water.

If there is a heavy rain and you are concerned that your pool overflowing will damage your home, take heart. This will not happen. The deck is designed to drain into the deco drains and out into the yard. With heavy rain flow, it will take some time for your overflow to catch up, but the water will still flow to the drains on the deck. The deck is also pitched to prevent water from flooding into the home.

It is normal to lose up to 2 inches of water in a week through normal evaporation. If you are heating your pool or causing excessive splashing, that could be an even bigger number. To see if you have a leak, consider the bucket test. To do this, fill the bucket and leave it on a step or sun shelf. Then, mark the inside of the bucket as well as the outside. They should both evaporate at the same rate. If one is noticeably different, then there could be a leak, and leak detection services will be needed.